8139too.o No such device !! master help!

Dyoxin

In /var/log/message
Feb  6 09:33:58 dyoxin adsl-connect: ADSL connection lost; attempting re-connection.

Feb  6 09:34:03 dyoxin pppd[6385]: pppd 2.4.1 started by root, uid 0

Feb  6 09:34:03 dyoxin pppd[6385]: Using interface ppp0

Feb  6 09:34:03 dyoxin pppd[6385]: Connect: ppp0 <--> /dev/pts/1

Feb  6 09:34:03 dyoxin kernel: 8139too Fast Ethernet driver 0.9.26

Feb  6 09:34:03 dyoxin insmod: /lib/modules/2.4.21-4.EL/kernel/drivers/net/8139too.o: init_module: No such device

Feb  6 09:34:03 dyoxin insmod: Hint: insmod errors can be caused by incorrect module parameters,

    including invalid IO or IRQ parameters.

   You may find more information in syslog or the output from dmesg

Feb  6 09:34:03 dyoxin insmod: /lib/modules/2.4.21-4.EL/kernel/drivers/net/8139too.o: insmod eth0 failed

Feb  6 09:34:03 dyoxin pppoe[6386]: ioctl(SIOCGIFHWADDR): Session 0: No such device

Feb  6 09:34:03 dyoxin pppd[6385]: Modem hangup

Feb  6 09:34:03 dyoxin pppd[6385]: Connection terminated.

Feb  6 09:34:03 dyoxin pppd[6385]:

Exit.

in /var/log/dmesg

Linux version 2.4.21-4.EL (bhcompile@daffy.perf.redhat.com) (gcc version 3.2.3 20030502 (Red Hat Linux 3.2.3-20)) #1 Fri Oct 3 18:13:58 EDT 2003
BIOS-provided physical RAM map:
BIOS-e820: 0000000000000000 - 000000000009fc00 (usable)
BIOS-e820: 000000000009fc00 - 00000000000a0000 (reserved)
BIOS-e820: 00000000000f0000 - 0000000000100000 (reserved)
BIOS-e820: 0000000000100000 - 0000000027ff0000 (usable)
BIOS-e820: 0000000027ff0000 - 0000000027ff3000 (ACPI NVS)
BIOS-e820: 0000000027ff3000 - 0000000028000000 (ACPI data)
BIOS-e820: 00000000fec00000 - 0000000100000000 (reserved)
0MB HIGHMEM available.
639MB LOWMEM available.
On node 0 totalpages: 163824
zone(0): 4096 pages.
zone(1): 159728 pages.
zone(2): 0 pages.
Kernel command line: ro root=LABEL=/
Initializing CPU#0
Detected 2019.921 MHz processor.
Console: colour VGA+ 80x25
Calibrating delay loop... 4023.91 BogoMIPS
Memory: 640236k/655296k available (1524k kernel code, 12496k reserved, 1086k data, 164k init, 0k highmem)
zapping low mappings.
Dentry cache hash table entries: 131072 (order: 8, 1048576 bytes)
Inode cache hash table entries: 65536 (order: 7, 524288 bytes)
Mount cache hash table entries: 512 (order: 0, 4096 bytes)
Buffer cache hash table entries: 65536 (order: 6, 262144 bytes)
Page-cache hash table entries: 262144 (order: 8, 1048576 bytes)
CPU: Trace cache: 12K uops, L1 D cache: 8K
CPU: L2 cache: 512K
Intel machine check architecture supported.
Intel machine check reporting enabled on CPU#0.
CPU:     After generic, caps: 3febfbff 00000000 00000000 00000000
CPU:             Common caps: 3febfbff 00000000 00000000 00000000
CPU: Intel(R) Pentium(R) 4 CPU 2.00GHz stepping 04
Enabling fast FPU save and restore... done.
Enabling unmasked SIMD FPU exception support... done.
Checking 'hlt' instruction... OK.
POSIX conformance testing by UNIFIX
Process timing init...done.
mtrr: v1.40 (20010327) Richard Gooch (rgooch@atnf.csiro.au)
mtrr: detected mtrr type: Intel
PCI: PCI BIOS revision 2.10 entry at 0xfa1a0, last bus=2
PCI: Using configuration type 1
PCI: Probing PCI hardware
PCI: Ignoring BAR0-3 of IDE controller 00:1f.1
Transparent bridge - Intel Corp. 82801BA/CA/DB/EB PCI Bridge
PCI: Using IRQ router PIIX [8086/24c0] at 00:1f.0
PCI: Found IRQ 5 for device 00:1f.1
isapnp: Scanning for PnP cards...
isapnp: No Plug & Play device found
Linux NET4.0 for Linux 2.4
Based upon Swansea University Computer Society NET3.039
Initializing RT netlink socket
apm: BIOS version 1.2 Flags 0x07 (Driver version 1.16)
Total HugeTLB memory allocated, 0
Starting kswapd
VFS: Disk quotas vdquot_6.5.1
aio_setup: num_physpages = 40956
aio_setup: sizeof(struct page) = 56
Hugetlbfs mounted.
pty: 2048 Unix98 ptys configured
Serial driver version 5.05c (2001-07-08) with MANY_PORTS MULTIPORT SHARE_IRQ SERIAL_PCI ISAPNP enabled
ttyS0 at 0x03f8 (irq = 4) is a 16550A
ttyS1 at 0x02f8 (irq = 3) is a 16550A
Real Time Clock Driver v1.10e
NET4: Frame Diverter 0.46
RAMDISK driver initialized: 256 RAM disks of 8192K size 1024 blocksize
Uniform Multi-Platform E-IDE driver Revision: 7.00beta4-2.4
ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx
ICH4: IDE controller at PCI slot 00:1f.1
PCI: Found IRQ 5 for device 00:1f.1
ICH4: chipset revision 2
ICH4: not 100% native mode: will probe irqs later
    ide0: BM-DMA at 0xf000-0xf007, BIOS settings: hdaMA, hdbMA
    ide1: BM-DMA at 0xf008-0xf00f, BIOS settings: hdcMA, hdd:pio
hda: Maxtor 6Y060L0, ATA DISK drive
hdb: Maxtor 6E040L0, ATA DISK drive
blk: queue c0417e80, I/O limit 4095Mb (mask 0xffffffff)
blk: queue c0417ff8, I/O limit 4095Mb (mask 0xffffffff)
hdc: SAMSUNG CD-ROM SC-152A, ATAPI CD/DVD-ROM drive
ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
ide1 at 0x170-0x177,0x376 on irq 15
hda: attached ide-disk driver.
hda: host protected area => 1
hda: 120103200 sectors (61493 MB) w/2048KiB Cache, CHS=7476/255/63, UDMA(100)
hdb: attached ide-disk driver.
hdb: host protected area => 1
hdb: setmax LBA 80293248, native  80287039
hdb: 80287039 sectors (41107 MB) w/2048KiB Cache, CHS=4997/255/63, UDMA(100)
ide-floppy driver 0.99.newide
Partition check:
hda: hda1 hda2 < hda5 hda6 hda7 hda8 hda9 >
hdb: hdb1 hdb2 < hdb5 >
ide-floppy driver 0.99.newide
md: md driver 0.90.0 MAX_MD_DEVS=256, MD_SB_DISKS=27
md: Autodetecting RAID arrays.
md: autorun ...
md: ... autorun DONE.
Initializing Cryptographic API
NET4: Linux TCP/IP 1.0 for NET4.0
IP: routing cache hash table of 8192 buckets, 64Kbytes
TCP: Hash tables configured (established 262144 bind 65536)
Linux IP multicast router 0.06 plus PIM-SM
Initializing IPsec netlink socket
NET4: Unix domain sockets 1.0/SMP for Linux NET4.0.
RAMDISK: Compressed image found at block 0
Freeing initrd memory: 161k freed
VFS: Mounted root (ext2 filesystem).
Journalled Block Device driver loaded
kjournald starting.  Commit interval 5 seconds
EXT3-fs: mounted filesystem with ordered data mode.
Freeing unused kernel memory: 164k freed
usb.c: registered new driver usbdevfs
usb.c: registered new driver hub
usb-uhci.c: $Revision: 1.275 $ time 18:21:59 Oct  3 2003
usb-uhci.c: High bandwidth mode enabled
PCI: Setting latency timer of device 00:1d.0 to 64
usb-uhci.c: USB UHCI at I/O 0xd800, IRQ 5
usb-uhci.c: Detected 2 ports
usb.c: new USB bus registered, assigned bus number 1
hub.c: USB hub found
hub.c: 2 ports detected
PCI: Setting latency timer of device 00:1d.1 to 64
usb-uhci.c: USB UHCI at I/O 0xd000, IRQ 9
usb-uhci.c: Detected 2 ports
usb.c: new USB bus registered, assigned bus number 2
hub.c: USB hub found
hub.c: 2 ports detected
PCI: Setting latency timer of device 00:1d.2 to 64
usb-uhci.c: USB UHCI at I/O 0xd400, IRQ 11
usb-uhci.c: Detected 2 ports
usb.c: new USB bus registered, assigned bus number 3
hub.c: USB hub found
hub.c: 2 ports detected
usb-uhci.c: v1.275:USB Universal Host Controller Interface driver
PCI: Setting latency timer of device 00:1d.7 to 64
ehci-hcd 00:1d.7: Intel Corp. 82801DB USB2
ehci-hcd 00:1d.7: irq 5, pci mem e8860000
usb.c: new USB bus registered, assigned bus number 4
ehci-hcd 00:1d.7: enabled 64bit PCI DMA
PCI: 00:1d.7 PCI cache line size set incorrectly (0 bytes) by BIOS/FW.
PCI: 00:1d.7 PCI cache line size corrected to 128.
ehci-hcd 00:1d.7: USB 2.0 enabled, EHCI 1.00, driver 2003-Jan-22
hub.c: USB hub found
hub.c: 6 ports detected
usb.c: registered new driver hiddev
usb.c: registered new driver hid
hid-core.c: v1.8.1 Andreas Gal, Vojtech Pavlik <vojtech@suse.cz>
hid-core.c: USB HID support drivers
mice: PS/2 mouse device common for all mice
hub.c: connect-debounce failed, port 1 disabled
EXT3 FS 2.4-0.9.19, 19 August 2002 on ide0(3,7), internal journal
Adding Swap: 1052216k swap-space (priority -1)
hub.c: new USB device 00:1d.2-1, assigned address 2
usb.c: USB device 2 (vend/prod 0xac8/0x301b) is not claimed by any active driver.
kjournald starting.  Commit interval 5 seconds
EXT3 FS 2.4-0.9.19, 19 August 2002 on ide0(3,6), internal journal
EXT3-fs: mounted filesystem with ordered data mode.

Master help! :help