安装mplay1。pre3完成，但不运行

liumao

用mplayer1。0pre3tar。bz2安转
  解压到用户目录下，并进入
   ＃./configure --enabke-gui --disable-mencoder --language＝zh_CN
   #make
   ＃make install
  都正常。在终端运行“／usr/local/bin/gmplay"显示如下：
Player 1.0pre3-3.3.1 (C) 2000-2003 MPlayer Team

CPU: Intel Pentium 4/Xeon/Celeron Northwood 2401 MHz (Family: 8, Stepping: 7)
Detected cache-line size is 64 bytes
CPUflags:  MMX: 1 MMX2: 1 3DNow: 0 3DNow2: 0 SSE: 1 SSE2: 1
Compiled for x86 CPU with extensions: MMX MMX2 SSE SSE2

Reading config file /usr/local/etc/mplayer/mplayer.conf: 没有那个文件或目录
Reading config file /root/.mplayer/config
[cfg] read config file: /root/.mplayer/gui.conf
Reading config file /root/.mplayer/gui.conf
vo: X11 running at 1024x768 with depth 16 and 16 bpp (":0.0" => local display)
Reading /root/.mplayer/codecs.conf: Can't open '/root/.mplayer/codecs.conf': 没 有那个文件或目录
Reading /usr/local/etc/mplayer/codecs.conf: Can't open '/usr/local/etc/mplayer/codecs.conf': 没有那个文件或目录
Using built-in default codecs.conf.
font: can't open file: /root/.mplayer/font/font.desc
font: can't open file: /usr/local/share/mplayer/font/font.desc
Using Linux hardware RTC timing (1024Hz).
Can't open input config file /root/.mplayer/input.conf: 没有那个文件或目录
Can't open input config file /usr/local/etc/mplayer/input.conf: 没有那个文件或目录
Falling back on default (hardcoded) input config
SKIN dir 1: '/root/.mplayer/Skin'
SKIN dir 2: '/usr/local/share/mplayer/Skin'
[skin] file ( /usr/local/share/mplayer/Skin/AlienMind/skin ) not found.
Selected skin ( AlienMind ) not found, trying 'default'...
[skin] file ( /usr/local/share/mplayer/Skin/default/skin ) not found.
Skin not found (default).
[root@localhost wei]#
请帮助，谢谢.

hutigers

最初由 liumao 发表
用mplayer1。0pre3tar。bz2安转
  解压到用户目录下，并进入
   ＃./configure --enabke-gui --disable-mencoder --language＝zh_CN
   #make
   ＃make install
  都正常。在终端运行“／usr/local/bin/gmplay"显示如下：
Player 1.0pre3-3.3.1 (C) 2000-2003 MPlayer Team

CPU: Intel Pentium 4/Xeon/Celeron Northwood 2401 MHz (Family: 8, Stepping: 7)
Detected cache-line size is 64 bytes
CPUflags:  MMX: 1 MMX2: 1 3DNow: 0 3DNow2: 0 SSE: 1 SSE2: 1
Compiled for x86 CPU with extensions: MMX MMX2 SSE SSE2

Reading config file /usr/local/etc/mplayer/mplayer.conf: 没有那个文件或目录
Reading config file /root/.mplayer/config
[cfg] read config file: /root/.mplayer/gui.conf
Reading config file /root/.mplayer/gui.conf
vo: X11 running at 1024x768 with depth 16 and 16 bpp (":0.0" => local display)
Reading /root/.mplayer/codecs.conf: Can't open '/root/.mplayer/codecs.conf': 没 有那个文件或目录
Reading /usr/local/etc/mplayer/codecs.conf: Can't open '/usr/local/etc/mplayer/codecs.conf': 没有那个文件或目录
Using built-in default codecs.conf.
font: can't open file: /root/.mplayer/font/font.desc
font: can't open file: /usr/local/share/mplayer/font/font.desc
Using Linux hardware RTC timing (1024Hz).
Can't open input config file /root/.mplayer/input.conf: 没有那个文件或目录
Can't open input config file /usr/local/etc/mplayer/input.conf: 没有那个文件或目录
Falling back on default (hardcoded) input config
SKIN dir 1: '/root/.mplayer/Skin'
SKIN dir 2: '/usr/local/share/mplayer/Skin'
[skin] file ( /usr/local/share/mplayer/Skin/AlienMind/skin ) not found.
Selected skin ( AlienMind ) not found, trying 'default'...
[skin] file ( /usr/local/share/mplayer/Skin/default/skin ) not found.
Skin not found (default).
[root@localhost wei]#
请帮助，谢谢.

:rolleyes: 知道了吧。
去mplayer的网站下载一个skin回来，我喜欢那个Blue，
之后解压，
之后把Blue改名为default
mv Blue default
在你的主目录下(就是/home/usrname)下，
建立目录。
mkdir -p ~/.mplayer/Skin
把default拷贝进去。
cp -r default ~/.mplayer/Skin/
现在就可以了。
gmplayer一下吧。

如果出现字体错误的提示，那就是没安装字体了。:rolleyes:

到时再说。

rxj

缺少皮肤