幫我看看有沒問題？

amylam

系統自檢時 new hardware .............................FAILED
# hdparm -i new hardware

hdparm - get/set hard disk parameters - version v5.5

Usage:  hdparm  [options] [device] ..

Options:
-a   get/set fs readahead
-A   set drive read-lookahead flag (0/1)
-b   get/set bus state (0 == off, 1 == on, 2 == tristate)
-B   set Advanced Power Management setting (1-255)
-c   get/set IDE 32-bit IO setting
-C   check IDE power mode status
-d   get/set using_dma flag
-D   enable/disable drive defect-mgmt
-E   set cd-rom drive speed
-f   flush buffer cache for device on exit
-g   display drive geometry
-h   display terse usage information
-i   display drive identification
-I   detailed/current information directly from drive
-Istdin  similar to -I, but wants /proc/ide/*/hd?/identify as input
-k   get/set keep_settings_over_reset flag (0/1)
-K   set drive keep_features_over_reset flag (0/1)
-L   set drive doorlock (0/1) (removable harddisks only)
-M   get/set acoustic management (0-254, 128: quiet, 254: fast) (EXPERIMENTAL)
-m   get/set multiple sector count
-n   get/set ignore-write-errors flag (0/1)
-p   set PIO mode on IDE interface chipset (0,1,2,3,4,...)
-P   set drive prefetch count
-q   change next setting quietly
-Q   get/set DMA tagged-queuing depth (if supported)
-r   get/set readonly flag (DANGEROUS to set)
-R   register an IDE interface (DANGEROUS)
-S   set standby (spindown) timeout
-t   perform device read timings
-T   perform cache read timings
-u   get/set unmaskirq flag (0/1)
-U   un-register an IDE interface (DANGEROUS)
-v   defaults; same as -mcudkrag for IDE drives
-V   display program version and exit immediately
-w   perform device reset (DANGEROUS)
-W   set drive write-caching flag (0/1) (DANGEROUS)
-x   tristate device for hotswap (0/1) (DANGEROUS)
-X   set IDE xfer mode (DANGEROUS)
-y   put IDE drive in standby mode
-Y   put IDE drive to sleep
-Z   disable Seagate auto-powersaving mode
-z   re-read partition table

amylam

硬盤：

/dev/hda:

Model=Maxtor 2F040J0, FwRev=VAM51JJ0, SerialNo=F126147E
Config={ Fixed }
RawCHS=16383/16/63, TrkSize=0, SectSize=0, ECCbytes=57
BuffType=DualPortCache, BuffSize=2048kB, MaxMultSect=16, MultSect=16
CurCHS=16383/16/63, CurSects=16514064, LBA=yes, LBAsects=74204236
IORDY=on/off, tPIO={min:120,w/IORDY:120}, tDMA={min:120,rec:120}
PIO modes:  pio0 pio1 pio2 pio3 pio4
DMA modes:  mdma0 mdma1 mdma2
UDMA modes: udma0 udma1 udma2 udma3 udma4 *udma5 udma6
AdvancedPM=yes: disabled (255) WriteCache=enabled
Drive conforms to: (null):

* signifies the current active mode