|
|
发表于 2006-8-4 18:10:12
|
显示全部楼层
VFS cannot open root device "hda4" or unknown block(0,0)
this means that you didn't compile the support for your storage controller in the kernel <*> and not as a module <M>. Look at the output of lspci to identify your storage controller.
Hate to double post, but jmbsvicetto is right...that's what I'm getting at regarding your drivers :wink:
Cheers,
Ok I checked and EXT3 was enabled.
Here are the controllers it found:
IDE interface: Intel 82801 IDE controller
IDE interface: Intel 82801 SATA controller
There are a lot of options on the ATA/ATAPI screen. So far I have ATA/ATAPI support, IDE/ATA disk2 support, Enhanced IDE/MFM/RLL disk support, generic PCI IDE bus master support. There are a bunch of specific chipsets and mine does not match with them. I do not have SATA support enabled (plus it says it conflicts with libata SATA driver). The drive is definitely not SATA, it's EIDE. The only intel chipset listed does not really match up with what I have. Intel pIIX chipset or something. Not sure what to select here. I did pick the default things that the guide told me though as far as I can tell. Everything I mentioned that is selected is not module [M].
还有，呵呵 |
|
IP卡
狗仔卡
显身卡